Nortel Networks HotWire 8600 - Manual (Page 46)

Initial Setup Instructions
3-2 8600-A2-GN20-20 October 1997
"
Procedure
To set the IP address and subnet mask from the console terminal:
1. Power up the chassis. After the self-test completes, the Who Am I screen will
appear.
2. From the Who Am I screen, enter the Management Domain IP address of the
MCC card and press the Return key. For example, if the IP address of the
MCC card is 198.152.152.50, type this value at the
(nnn.nnn.nnn.nnn):
prompt as illustrated below.
The system automatically calculates the subnet mask based on the IP
address you enter.