National Instruments NI VXIpc-882 - Manual (Page 68)

Chapter 5 I/O Information
NI VXIpc-882 User Manual 5-10 ni.com
SMB TRGIN/OUT and EXTCLK
The TRG connectors are the software-controlled trigger connections for
routing VXI triggers to or from the VXI backplane. For more information,
refer to the
Front Panel SMB TRGIN/TRGOUT section of Chapter 3,
Configuration and Default Settings .
Figure 5-6 shows the TRG connector locations on the NI VXIpc-882.
Table 5-8 lists and describes the trigger connector signals.
Figure 5-6. SMB Connector Location and Pinout
Table 5-8. TRIG/CLK Connector Signals
Pin Signal Name Signal Description
1 SIGNALCONDUCTOR Trigger/CLK
2 (Shield) GND Ground
1
2
TRIG IN
1
2
1
2
TRIG OUT
EXT CLK (CLK10)