Roland VG-88 - Manual (Page 26)

26
Chapter 3. Creating sounds — basic section
6. Press [F4] (PATCH B).
fig.3-05
7. Turn [VALUE] to select the other patch that you wish to
exchange.
8. Press [F6] (EXCHANGE) to exchange the patches.
The display will indicate “NOW EXCHANGING.”
9. When you have finished exchange, press [EXIT] two
times. You will return to Play page.
Very simple sound editing (EZ Edit function)
This method lets you create a sound by selecting one of the
preset sounds and adjusting only four parameters (DRIVE,
TONE, MOD, DELAY). Since you can also start with a patch
and modify it, it's easy to create the desired sound even if
you are not sure of the effect or settings of each effect unit.
The preset sounds are classified into several Types, and each
type has several Colors.
fig.3-07
1. Press [EZ EDIT]. The EZ Edit screen will appear.
2. Press [F1] (TYPE), and turn [VALUE] to select the
desired TYPE.
* If you set type to “PATCH DATA,” you can create a sound
using the sound obtained by changing to the EZ Edit function.
ig.3-08
3. Press [F4] (COLOR), and turn [VALUE] to select a sound.
* If you have set TYPE to “PATCH DATA,” it will not be
possible to change the COLOR.
4. Press [F2] (DRIVE), and turn [VALUE] to adjust the
amount of distortion or sustain.
* If you have TYPE set to “PATCH DATA,” then when
DRIVE is set to “PATCH DATA,” distortion and sustain are
set to the same amount set in the original Patch data.
5. Press [F3] (TONE), and turn [VALUE] to adjust the tone.
* If you have TYPE set to “PATCH DATA,” then when TONE
is set to “PATCH DATA,” distortion and sustain are set to
the same amount set in the original Patch data.
6. Press [F5] (MOD), and turn [VALUE] to adjust the depth
or modulation of the sound.
* If you have TYPE set to “PATCH DATA,” then when MOD
is set to “PATCH DATA,” distortion and sustain are set to
the same amount set in the original Patch data.
7. Press [F6] (DELAY), and turn [VALUE] to adjust the
reverberation of the sound.
* If you have TYPE set to “PATCH DATA,” then when
DELAY is set to “PATCH DATA,” distortion and sustain are
set to the same amount set in the original Patch data.
8. When you are finished creating the sound, perform the
Write operation (p. 25) if you wish to save your newly
created sound.
* If you do not want to save the sound, press [EXIT] to return to
Play page.
2,3,4,5,6,7
1
2
3 7 6
4 5