Roland PCR-500 - Manual (Page 15)

15
Using PCR Editor
If you have not yet installed PCR Editor in your computer, install it now as
described in the included setup guide.
1 Use a USB cable to connect the PCR to your computer, then switch on the PCR’s
power.
2 In Windows, choose [Start]-[All Programs]-[PCR Editor V2]-[PCR Editor 2] to start
up PCR Editor.
3 In PCR Editor, choose [Options]-[MIDI Devices].
fig.WinMIDIPort-e.eps
4 In the MIDI Devices dialog box, make the MIDI
device settings shown in the illustration.
5 Click [OK] to close the dialog box.
If you have not yet installed PCR Editor in your computer, install it now as
described in the included setup guide.
1 Use a USB cable to connect the PCR to your Mac, then switch on the PCR’s
power.
2 From the Mac Finder, open the [Applications]-[PCR Editor V2] folder, and
double-click PCR Editor V2 to start up PCR Editor.
3 In PCR Editor, choose [Options]-[MIDI Devices].
fig.MacMIDIPort-e.eps
4 In the MIDI Devices dialog box, make the MIDI
device settings shown in the illustration.
5 Click [OK] to close the dialog box.
Windows users
* Microsoft and Windows are registered trademarks of Microsoft Corporation.
* The screen shots in this document are used in compliance with the guidelines of the Microsoft
Corporation.
* Windows ® is known officially as: “Microsoft ® Windows ® operating system.”
Mac OS X users
* Apple and Macintosh are registered trademarks of Apple Computer, Inc.
* Mac OS is a trademark of Apple Computer, Inc.
PCR-300_500_800_e.book 15 ページ ２００６年１２月１９日 火曜日 午後２時５９分