Roland PCR-500 - Manual (Page 30)

30
Using PCR Editor
Assign a MIDI message.
You can enter up to twenty-four bytes. You may assign more than one MIDI message
if desired.
fig.EditorFreeMessage.eps_35
You can specify the following parameters for Free Message.
Assign tempo control for transmitting MIDI Clock messages.
fig.EditorTempo.eps_35
There are no parameters to specify for Tempo.
Free Message [...]
Item Content
Message entry field
You can enter a MIDI message of up to twenty-four bytes. Enter
each byte as a hexadecimal value separated by a single-byte
space.
The following limitations apply to the input.
* You can’t use a checksum.
* You can’t use a special character as the first byte.
You can also enter variable data using the special characters de-
scribed in
Table 1: Special characters used in the message entry
field (p. 29). If you use the special character “DT,” use the Data
Type field to specify the type of data.
Data Type
If you’ve used the special character “DT” in the message entry
field, use this to specify the type of data to be inserted at that lo-
cation. For the types of data that can be specified, refer to
Table
2: Types of data you can specify in the Data Type field (p. 29).
Min Value Lower limit of the data value
Max Value Upper limit of the data value
Tempo
PCR-300_500_800_e.book 30 ページ ２００６年１２月１９日 火曜日 午後２時５９分