Switching control maps, Saving a control map, Switching control maps saving a control map – Roland PCR-500 User Manual
Page 9: P. 9)), P. 9)
9
Using control maps
When the PCR-300/500/800 is shipped from the factory, it contains sixteen control
maps. By switching among these control maps, you can quickly select control maps
that are suitable for a wide variety of software. For details on the memory numbers of
these control maps and their factory settings, refer to
fig.H-MemorySet.eps
1
Press the [CONTROL MAP] button.
The [CONTROL MAP] button will light.
The display will indicate the currently selected
memory number.
2
Turn the [VALUE] dial to select the memory
number you want to call up.
If you want to keep the changes you’ve made to the current memory, use the following
procedure to save the control map.
You can save the control map in memory numbers 1–F. You can’t save to memory
number 0.
* If you’ve changed the settings of the current memory, be sure to “SAVE” if you want to keep
your changes.
fig.H-Edit.eps
1
Press the [EDIT] button so it’s lit.
fig.D-Edit.eps
The display will indicate “EDIT.”
fig.D-Save.eps
2
Turn the VALUE knob to make the display indicate “SAVE.”
fig.D-Protect.eps
3
Press the [ENTER] button.
* If the display indicates “PTC,” the Protect setting is ON, and you’ll be
unable to save the memory. Turn the Protect setting OFF, and repeat the
procedure from step 1.
(->
4
Use the VALUE knob or controllers [A1]–[A8] and [B1]–[B8] to specify the
memory number “1”–”F” in which you want to save the control map. The
specified memory number will blink in the display.
5
Press [ENTER] to save the control map.
* If you press another button instead of the [ENTER] button, the Save operation will be cancelled.
Switching control maps
You can also switch control maps using the following method.
1.
Press the [EDIT] button so it’s lit. The display will indicate “EDIT.”
2.
Press the [CONTROL MAP] button. It will light, and the display will
indicate the currently selected memory number.
3.
Use controllers [A1]–[A8], [B1]–[B8], or the VALUE knob to specify the
memory number you want to call up.
4.
Press the [ENTER] button.
Saving a control map
PCR-300_500_800_e.book 9 ページ ２００６年１２月１９日 火曜日 午後２時５９分