Roland PCR-500 - Manual (Page 74)

74
System settings
Here’s how to specify the port that will transmit performance data from the keyboard
and bender lever.
1 Press the [EDIT] button so it’s lit.
The display will indicate “EDIT.”
2 Use the VALUE knob to select “SYS,” and press the [ENTER] button.
3 Use the VALUE knob to select “SY04,” and press the [ENTER] button.
4 Use the VALUE knob or controllers [A1]–[A3] to specify the desired Keyboard
Port.
The display will show the setting you specified.
5 Press the [ENTER] button to return to Play mode.
Here’s how to specify the aftertouch response of the keyboard.
1 Press the [EDIT] button so it’s lit.
The display will indicate “EDIT.”
2 Use the VALUE knob to select “SYS,” and press the [ENTER] button.
3 Use the VALUE knob to select “SY05,” and press the [ENTER] button.
4 Use the VALUE knob or controllers [A1]–[A4] to specify the desired Keyboard
Aftertouch Curve.
The display will show the setting you specified.
5 Press the [ENTER] button to return to Play mode.
Keyboard Port Set
Controller Indication Setting Summary
[A1 (0)] PORT 1
Messages will be sent to
“EDIROL PCR 1.”
[A2 (1)] PORT 2
Messages will be sent to
“EDIROL PCR 2.”
[A3 (2)] PORT 1+2
Messages will be sent to
“EDIROL PCR 1” and
“EDIROL PCR 2.”
Keyboard Aftertouch Curve
Controller Indication Setting Curve type Effect
[A1 (0)] 1
This is the most typical set-
ting. It will produce the most
natural correspondence be-
tween the pressure you apply
to the keyboard and the af-
tertouch data that is pro-
duced.
[A2 (1)] 2
Compared to curve 1, this al-
lows aftertouch to be pro-
duced even with light
pressure on the keyboard.
[A3 (2)] 3
This curve produces less af-
tertouch change in response
to pressure on the keyboard,
making it easier to perform
consistently.
[A4 (3)] 4
Compared to curve 1, this
will produce aftertouch in re-
sponse to strong pressure on
the keyboard.
1
2
3
4
PCR-300_500_800_e.book 74 ページ ２００６年１２月１９日 火曜日 午後２時５９分