Roland PCR-500 - Manual (Page 48)

48
Settings (Edit mode)
Here’s how to assign a program change message to a controller.
Basic editing (-> Advanced editing 1, 2 (p. 50), Advanced editing 3 and 4 (p. 51))
fig.H-Edit.eps
1 Press the [EDIT] button so it’s lit.
fig.D-Edit.eps
The display will indicate “EDIT.”
fig.D-r1.eps
2 Slightly move the controller to which you want to assign a program
change message.
If the controller is a button, press it.
The display will indicate the number of the controller you selected.
3 Check the indication in the display, then press the [ENTER] button.
fig.D-PC.eps
4 Turn the VALUE knob to make “PC” appear.
5 Press the [ENTER] button.
fig.D-PCEdit0.eps
6 Turn the VALUE knob or press controller [A1 (0)] to select the basic
editing “PC0” indication.
fig.D-ChannelSelect.eps
7 Press the [ENTER] button.
The display will indicate “CH- -.”
* The - - portion shows the currently specified value.
8 Enter the channel. Use the VALUE knob or controller [A1 (0)]–[B2 (9)] to specify
the desired channel.
Program change assign
Edit Controller Display
MIDI transmit
channel
Bank MSB Bank LSB Value range Port
Basic editing [A1 (0)] 1–16 — —
0–127
(00–7FH)
PORT 1
(fixed)
Advanced editing 1 [A2 (1)] 1–16 — —
You can specify an
upper and lower limit
PORT 1
(fixed)
Advanced editing 2 [A3 (2)] 1–16
0–127
(00–7FH)
0–127
(00–7FH)
0–127
(00–7FH)
PORT 1,
PORT 2,
PORT 1+2
Advanced editing 3 [A4 (3)] Current channel — — PC DEC
PORT 1
(fixed)
Advanced editing 4 [A5 (4)] Current channel — — PC INC
PORT 1
(fixed)
PCR-300_500_800_e.book 48 ページ ２００６年１２月１９日 火曜日 午後２時５９分