Ricoh AFICIO MP01 - Manual (Page 23)

SETTING UP
1-2
REQUIREMENTS
Before using this machine you must make sure that you have met all of the
environmental and electrical requirements. You must also connect the machine
to your host computer using the parallel port, optional network interface card
(NIC), or both. Make sure that you have all of the cables, connectors, and
electrical outlets necessary to attach the machine to your host computer or
network.
☛ Refer to the “Connecting to the Host Computer” in this chapter for further
information on using the parallel port.
☛ Refer to the “Using the Options” chapter in this manual for information on
using the NIC to connect to a network.
Environmental Requirements
The location of the machine is important, because environmental conditions
can greatly affect its performance. Keep the following in mind when setting up
the machine:
❐ Make sure you set up the machine in an easily accessible area where the
temperature ranges between 10 - 32°C (50 - 90°F), and where relative
humidity is 20 - 80 %. The location should be no higher than 2000 m (6600
feet) above sea level.
❐ Make sure to locate the machine in a well-ventilated room with good air
circulation.
❐ Make sure that the machine is on a sturdy, level surface with a minimum
free area of 750 mm (29.6") above the machine, 20 mm (1") on each side
when the trays and covers are open. There should also be 130 mm (5")
clearance in rear and a comfortable working area in front of the machine.
The area where you install the machine should be subject to little or no
vibration.