Ricoh Network Guide - Manual (Page 59)

LDAP Server Settings
53
2
To set authentication
To make a search request to the LDAP
server, use the administrator account
for authentication.
For details about the administrator
account, see “To enter the user name
and password”.
AAAA
Press [
TNext].
B
Press [On] or [High Security] under
[Authentication]
.
Note
❒ Authentication settings must
comply with your server’s au-
thentication settings. Check
your server settings before set-
ting this machine.
❒ [High Security] is available only
with LDAP Version 3.0.
❒ When [High Security] is selected,
the administrator password is
encrypted before it is sent to the
network. When [On] is selected,
the password is sent without
encryption.
To enter the user name and
password
When [On] or [High Security] is selected
for the authentication setting, use the
administrator account name and
password. Do not enter the adminis-
trator account name and password
when using authentication for each
individual or each search.
AAAA
Press [
TNext].
BBBB
Press [Change] under [User Name].
CCCC
Enter the user name, and then
press [OK].
Note
❒ Procedures for the user name
setting differ depending on
server environment. Check
your server environment before
making the setting.
• Example setting procedures:
Domain Name\User Name
User Name@Domain Name
CN=Name, OU=Department
Name, DC=Server Name
DDDD
Press [Change] under [Password].
EEEE
Enter the password, and then
press [OK].