Setting parameters on a linux platform, To set parameters using the ethtool utility, To set parameters using the – Oracle Audio Technologies Sun Oracle SunDual 10GbE XFP User Manual
Page 54
44
Sun Dual 10GbE XFP PCI Express Card User’s Guide • May 2010
Setting Parameters on a Linux Platform
▼ To Set Parameters Using the ethtool Utility
1. Determine which parameters are available using the ethtool utility:
# ethtool -help eth4
ethtool version 1.8
Usage:
ethtool DEVNAME
ethtool -a DEVNAME
ethtool -A DEVNAME \
[ autoneg on|off ] \
[ rx on|off ] \
[ tx on|off ]
ethtool -c DEVNAME
ethtool -C DEVNAME \
[adaptive-rx on|off] \
[adaptive-tx on|off] \
[rx-usecs N] \
[rx-frames N] \
[rx-usecs-irq N] \
[rx-frames-irq N] \
[tx-usecs N] \
[tx-frames N] \
[tx-usecs-irq N] \
[tx-frames-irq N] \
[stats-block-usecs N] \
[pkt-rate-low N] \
[rx-usecs-low N] \
[rx-frames-low N] \
[tx-usecs-low N] \
[tx-frames-low N] \
[pkt-rate-high N] \
[rx-usecs-high N] \
[rx-frames-high N] \
[tx-usecs-high N] \
[tx-frames-high N] \
[sample-interval N]
ethtool -g DEVNAME
ethtool -G DEVNAME \
[ rx N ] \
[ rx-mini N ] \