Oki 59502 - Manual (Page 114)

|
OKIFAX 5750/5950 114
ECM Function
Speed access no. 20
The error correction mode (ECM) function is provided to
improve communications in areas where telephone line
conditions are very poor.
Available settings are ON and OFF.
The default setting is ON.
Sender ID Switch
Speed access no. 23
This function determines if the Sender ID is to be printed on
the transmitted fax. When set to ON, the ID is included on
the fax.
Available settings are ON and OFF.
The default setting is ON.
! In the United States, FCC regulation states that fax
machines must identify the sender and the telephone
number of the sender on each page of every fax sent.
Pulse Dial Rate
Speed Access no. 46
If the machine is set to Dial Pulse, this function controls the
rate of the dialing pulses (which vary by country).
Available settings are 10, 16 and 20 pps.
The default setting is MF (Modulated Frequencies).
See “Setting Basic Features, Dial and Incoming Call
Parameter Settings.”
Pulse Make Ratio
Speed access no. 47
If the machine is set to Dial Pulse, this function controls the
make rate of the dialing pulses.
Available settings are 33, 39 and 40%.
The default setting is 39.
Pulse Dial Type
Speed access no. 48
If the machine is set to Dial Pulse, this function controls the
type of pulse dialing it uses. Types of pulse dialing vary by
country.
Available settings are N, 10-N and N+1.
The default setting is N.