Oki 7300e - Manual (Page 10)

Configuration 9
Self-diagnostic test
With the printer power switched on, press the push-button for more
than three seconds and release. The self-diagnostic test results and
configuration settings are printed.
Printed self-diagnostic test sample
EthernetBoard OkiLAN 7300e Version 1.1.0
*** Diagnostic report ***
ROM check: Ok stat:7C31 FFFF 0000 0000
RAM check: Ok stat:0000 0000 0000 0000
EEPROM Check: Ok stat:8954 8954 0000 0000
DIPSW1:OFF(ON:Test use only
DIPSW2:OFF(ON:Initialize configuration)
DIPSW3:OFF(ON:Reserved)
DIPSW4:OFF(ON:Diagnostic print)
If “NG” is displayed instead of “OK” see the “Troubleshooting”
chapter.
Printed configuration settings sample
OkiLAN 7300e Version 1.1.0
*** Configuration report ***
TCP/IP protocol:ENABLE
IP address:192.168.20.127
Subnet mask:255.255.255.0
Gateway address:192.168.20.1
RARP protocol:DISABLE
DHCP/BOOTP protocol:ENABLE
DNS server (Pri.):192.168.20.2
DNS server (Sec.):192.168.20.3
root password:““
Authentic community:“******”
Trap communit:“public”
Trap address:0.0.0.0
SysContact:““
SysName:““
SysLocation:““
DefaultTTL:255
Enable AuthenTrap:2
Network protocol:ENABLE
OkiLan7300e Packet type:AUTO
NIC check: Ok addr:00:80:92:00:13 9D 100BASET-TX
00:80:92:00:13:9D is the Ethernet address.
Push-button