Netbeui – Oki 7300e User Manual
Page 140
Troubleshooting 139
If the network resides in a Zone, check the correct Zone name is
selected in the Chooser.
Check the Zone name in the utility related to the NIC is the same as the
Zone name set in NIC.
Check AppleTalk, which is displayed at the right bottom of the
Chooser, is set to
Enable. (In some OS versions Network is used
instead of AppleTalk.)
Check
Ethernet is selected in AppleTalk. (In some OS versions
Network is used instead of AppleTalk.)
Check the print driver is selected in the Chooser.
Check the EtherTalk protocol is set to
Enable.
Print the NIC settings and confirm that the EtherTalk Port name is not
blank.
NetBEUI
The network interface card is not identified.
Turn the printer off and on again.
Check the network cable is correctly connected.
Change the cable and try again.
Check
Microsoft network client and NetBEUI have been added to the
network section of the control panel.
Check the NetBEUI protocol is set to
Enable.
Check the factory setting of the workgroup name is
PrintServer and
the computer name is ML+ the last six digits of the MAC address.
Check the computer name of the NIC is different from the computer
name on the network.