Oki 7300e - Manual (Page 61)

Configuration 60
SNMP-1 [OKI Device
Setup]-
[SNMP]-
[Authentic
Community] [Network
Configuration]-
[SNMP Traps]-
[MIB-II Information]-
[Authentic
Community] [Setup SNMP]-
[Authentic
community] Any
alphanumeric
characters up to
15 characters.
(Default is
[
public])
This
community
name is used
to check
whether
incoming
SNMP
requests have
the correct
community
name or not.
The
community
name is
displayed as
****** for
security
reasons
SNMP-2 [OKI Device
Setup]-
[SNMP]-[TRAP
Community] [Network
Configuration]-
[SNMP Traps]-
[MIB-II Information]-
[Trap Community] [Setup SNMP]-
[Trap community] Any
alphanumeric
characters up to
15 characters.
(Default is
[
public])
This
community
name is
assigned to
outgoing
system traps
such as cold
start,
authenti-
cation failure,
etc.
SNMP-3 [OKI Device
Setup]-
[SNMP]-
[TRAP
Address] [Network
Configuration]-
[SNMP Traps]-
[MIB-II Information]-
[Trap IP Address] [Setup SNMP]-
[Trap address] 0.0.0.0—
255.255.255.2
55 (
0.0.0.0)
Set a
destination IP
address of
Trap packet. If
0.0.0.0 is set,
Trap is
disabled
SNMP-4 [OKI Device
Setup]-
[SNMP]-
[SysContact] [Network
Configuration]-
[General Settings]-
[System
Information]-
[System Contact] [Setup SNMP]-
[SysContact] Any
alphanumeric
characters up to
255 characters.
(Default is
null)
Set
SysContact
(printer
manager)
name
SNMP-5 [OKI Device
Setup]-
[SNMP]-
[SysName] [Network
Configuration]-
[General Settings]-
[System
Information]-
[System Name] [Setup SNMP]-
[SysName] Any
alphanumeric
characters up to
255 characters.
(Default is
null)
Set SysName
(printer model
name)
SNMP-6 [OKI Device
Setup]-
[SNMP]-
[SysLocation] [Network
Configuration]-
[General Settings]-
[System
Information]-
[System Location] [Setup SNMP]-
[SysLocation] Any
alphanumeric
characters up to
255 characters.
(Default is
null)
Set Sys-
Location (the
location
where the
printer is
installed)
Ref. No. Admin
Manager Web browser TELNET/
Diagnostic test
print Available
options Notes