Oki 7300e - Manual (Page 136)

Troubleshooting 135
TROUBLESHOOTING
The network addresses used in this manual are shown for example
only. Network addresses used in your installation must be generated
from your own network.
Self-diagnostic test
Printer does not print.
Ensure the printer emulation is set to PS or Automatic.
NG is printed in the Self-diagnostic test.
*** Diagnostic report ***
ROM Check :Okstat:EFCC FFFF 0000 0000
RAM Check :Okstat:0000 0000 0000 0000
NIC Check :Okaddr:00:80:92:00:13:01
100BASE-TX
EEPROM Check:Okstat:8DD0 8DD0 0000 0000
ROM Check and RAM Check register NG.
Confirm that the network interface card (NIC) is installed correctly and
turn the printer off and on again.
NIC check registers NG.
Confirm that the NIC is installed correctly and turn the printer off and
on again.
Ensure the network cable is correctly connected and connect to a
different network segment, rerun the test and see if this cures the
fault.
EEPROM Check registers NG.
Confirm that the NIC is installed correctly and turn the printer off and
on again.
Initialize the NIC.