Quadra-Fire CB1200-B - Manual (Page 18)

Page 18 7014-082D September 1, 2008
R CB 1200 Pellet Stove
R R
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
1. Put a layer of high temperature silicone on the  inch
(76mm) exhaust outlet.
2. Slide the top vent adapter onto the rear exhaust outlet
and adjust the assembly to a vertical position.
. Drill 4 holes with #26 drill bit (provided) into the back of
the appliance using the outer shield as a pattern (make
sure the assembly is vertical). Figure 18.1
4. Install the 4 mounting screws.
5. Install the vent pipe into the top vent adapter (be sure
to silicone all joints).
6 To clean the top vent adapter, open the clean-out cover.
See Figure 18.1
B. Top Vent Adapter Installation
Installing the Top Vent Adapter
" - 6"
Offset
Adapter
" - "
Top Vent
Adapter
Drill holes in back of
stove and secure with 4
screws, 2 on each side.
Clean Out
Cover
Figure 18.1
C. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Clean-Out Cover
Clean-Out Cover
Figure 18.2 - Rear Vent Adapter
Figure 18.3 - Rear to Top Vent Adapter - 90o
1. Put a layer of high temperature silicone on the  inch
(76mm) exhaust outlet.
2. Slide the adapter onto the rear exhaust outlet and adjust
the assembly to the appropriate position.
. Install the vent pipe into the adapter (be sure to silicone
all joints)