E. blower replacement, Cb 1200 pellet stove, D. high ash fuel content maintenance – Quadra-Fire CB1200-B User Manual

Page 32

Advertising
background image

Page 2

7014-082D

September 1, 2008

R

CB 1200 Pellet Stove

R

R

Correct Flame Size, Yellow/White in Color

Correct

Figure 32.3

Ash Build Up in Firebox

Pellets Back Up

In Feed Tube

Firepot Overfills

Tall, Lazy Flame, Orange in Color

Incorrect

Figure 32.1

Figure 32.2

D. High Ash Fuel Content Maintenance

• Frequency: When the ash build-up exceeds more

than half way up the firepot.

• By: Homeowner

1. Convection Blower Replacement
a. Use proper shut down procedures to shut down the

appliance and let it completely cool.

b. The convection blower is located at the bottom rear

of the appliance. If an outside air kit is also installed,

depending on your particular installation you may or

may not have to remove the outside air flange. If you

do, remove the 2 screws using a Phillips head screw-

driver. You do not need to remove the flex pipe from

the flange.

c. Remove the lower rear screen by removing the 4

screws securing the screen to the unit.

d.

The motor is mounted on a removable bracket. Remove the

2 screws just above the motor and the whole assembly will tilt

down and pull out.

e.

Disconnect the wires from the blower. The wires coming

from the wiring harness are white, red and tan and the

wires coming from the blower are black, white and red.

The white connects to white, the red to red and black to

the tan color wire.

E. Blower Replacement

Figure 32.4

Remove 2 Screws

Remove 4 Screws

Outside Air

Flex Hose

Convection Blower

Poor quality pellet fuel, or lack of maintenance, can create

conditions that make the firepot fill quickly with ashes and

clinkers.
This condition makes the appliance susceptible to overfill-

ing the firepot with pellets which may result in smoking,

sooting and possible hopper fires.

Figure 32.1 shows an

example where the firepot overfills, pellets back up into the

feed tube and ash has accumulated in the firebox.
An inefficient and non-economical method of burning of

fuel caused by poor quality pellet fuel

is shown in

Figure

32.2.
The correct flame size when good quality, premium pellet

fuel is burned is shown in

Figure 32.3.

If the ash buildup exceeds the half way point in the firepot

IMMEDIATE ATTENTION AND CLEANING IS REQUIRED.

Advertising