Caution, Install logo, Cb 1200 pellet stove – Quadra-Fire CB1200-B User Manual

Page 20: G. optional gold or nickel grille assembly, F. optional log set placement instructions, H. installing logo (nickel only)

Advertising
background image

Page 20

7014-082D

September 1, 2008

R

CB 1200 Pellet Stove

R

R

G. Optional Gold or Nickel Grille Assembly

1. Place the front log in first as shown in

Figure 20.1. Place

log between firepot and face of appliance with charred

area surrounding firepot.

2. Set the left and right logs onto the front log, placing

the holes in the base of the left and right logs over the

locating pins in front log. See

Figure 20.2. Ensure that

the charred ends are facing the firepot.

F. Optional Log Set Placement Instructions

CAUTION

Logs are FRAGILE. Use extreme care when handling or

cleaning logs.

NOTE:

Due to the abrasive nature of a pellet appliance fire, the

logs are not covered under warranty. Any placement varia-

tion other than shown here can cause excessive heat and

shall void the appliance warranty.

LOCATING PINS

Charred Areas in the Back

Top Log

Right

Top Log, Left

Front Log

Figure 20.1

Figure 20.2

Place 1 flap of

box lid into

opening for

stability

CAUTION: Do not open top all the way back so the weight is

supported by the hinges. It will damage the hinges. Prop the

top up with supporting brace or use shipping box as shown.

Align the 3 hoes in the stove

with the holes in the grille and

secure in place.

1. Remove grille from packaging.
2. Lift top up and place shipping box in vertically.
. Place 1 flap of the box lid into opening for stability.
4. Align the  holes in the stove with the holes in the grille.
5. Use a Phillips screwdriver to secure in place.
6. Remove shipping box and lower top.

Install Logo

1. Remove logo from packaging.
2. The logo has 2 studs on the back.
. Install the logo on the lower left side of the center

panel by pressing the 2 studs into the pre-drilled

holes.

See Figure 20.4.

Do not open top all the way back so the weight of the

top is supported by the hinges.

It will damage the

hinges. It will be necessary to prop the top up with

a supporting brace. You can use the shipping box as

shown in Figure 1.

CAUTION

Figure 20.3

H. Installing Logo (Nickel Only)

Figure 20.4

Advertising