Quadra-Fire MTVERNON-AE-CWL - Manual (Page 26)

Page 26 7034-106E September 1, 2008
R Mt. Vernon Pellet Stove (AE)
H. Quick Start Guide
R A
Set at
P
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
2. Highlight “FUEL TYPE” using the “UP/
DOWN” buttons to the right side of the
display. Press “SELECT”.
A to/ an al/ ff
ser Settings
Fuel Type
MENU
Set Comfort Level
3. Scroll down and highlight “HARD-
WOOD PELLET” or your fuel type.
S nflo er Seeds
heat
F L S L C
Soft ood Pellet
ard ood Pellet
5. Press “DONE” to confirm fuel
change.
C F R F L C A
Please empt hopper
of old f el t pe and
ens re fire o is lean
Please refer to
se tion in man al
DONE
2. Highlight “AUTO/MANUAL/OFF”.
Press “SELECT”.
ser Settings
F el pe
Set Comfort Level
A to/ an al/ ff
3. Highlight “MANUAL”. Press “SELECT ”.
A / A AL S S
an al
ff
A tomati
an al
CHOOSING FUEL TYPE
TURNING ON APPLIANCE
7. Fill the hopper with fuel, and if the
hopper was completely empty, or has
run out of fuel, throw approximately
1/2 cup of pellets into the firepot.
8. Be sure the hopper lid and glass
door are both closed.
1. At the starting screen, press “MENU”.
Function Buttons
ttons
Up
Down
R A
Set at
P
HEAT OUTPUT MENU
Room
Temp
Wall Control for Reference
6. Press “DONE” twice or wait 15 sec-
onds for starting screen to reap-
pear.
4. Press “DONE” twice or wait 15 seconds
for starting screen to reappear.
R A
Set at
P
MENU
4. Now press “SELECT” to choose new
fuel
R A
Set at
P
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
2. Highlight “TEMP UNITS F/C” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
CHOOSING TEMP UNIT:
°F or °C
4. Press “DONE”. Press “DONE” again,
or wait 15 seconds for starting screen
to reappear.
3. Press the “UP” or “DOWN” button
to set desired temperature unit and
press “SELECT”..
S R S S
Flame eight Ad st
emp ifferential
emp nits F/C
A to/ an al/ ff
F el pe
Set Comfort Level
ser Settings
2. Highlight “USER SETTINGS” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
NOTICE: Any button pressed will turn on the backlight. Wall control will automati-
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the “CONFIRM FUEL CHANGE” screen.