Quadra-Fire MTVERNON-AE-CWL User Manual

Page 32

Advertising
background image

Page 32

7034-106E

September 1, 2008

R

Mt. Vernon Pellet Stove (AE)

6.

Cleaning Firepot with Firepot Clean-Out Tool

Frequency:

Softwood

Pellets: Weekly or every 5 bags

Hardwood Pellets: Weekly or every 3 bags

Alternate Pellets: Daily or every 1 bag

By: Homeowner

a. The appliance must be in complete shutdown,

completely cool and the exhaust blower off.

b. It may be necessary to use your firepot clean-out tool

to chip away material that has built up on the sides of
the firepot and to push out any clinkers. Larger clinkers
may have to be removed from the top of the firepot.

Corn clinkers can be especially difficult to break up. If

the clinker adheres to the sides of the firepot, you will
need to manually clean the firepot.

c. After cleaning the firepot and inspecting the holes,

turn off the power and then restore the power. The
auto- clean system will then clean itself.

d. The firepot floor plate must be fully closed when

finished.

7.

Cleaning Heat Exchanger & Drop Tube

Frequency: Monthly or every 1 ton of fuel

By: Homeowner

a. The appliance must be in complete shutdown,

completely cool and the exhaust blower off.

b. It is necessary to remove the baffle to gain access

to the heat exchanger. Follow instructions for baffle
removal on page 35.

c. Vacuum the ash from the heat exchanger with an

upholstery brush to remove the majority of the ash.
Be sure to vacuum the back of the baffle also. Inspect
the drop tube and remove any residue build-up in the
drop tube. Figure 323.1.

Figure 32.2

Figure 32.3

e.

U

se the crevice tool to finish cleaning the heat

exchanger fins. It is critical that the 2 exhaust exits
at the back of the firebox floor (left and right) be
thoroughly cleaned. Figure 33.4. There are several
ways this can done.

1. Use the crevice tool.

2. Attach a hose 1/2 inch (12.7mm) in diameter and

approximately 2 feet (607mm) in length to your
vacuum hose.

3.

Use a bottle brush and push the ash down to the
bottom. Remove the exhaust blower and then
vacuum out the ash. Figures 33.1-4 on page 33.

Figure 32.1

exhaust exits left and right side must
e thoroughly cleaned. Each exit is

approximately 4 inches wide, 1 inch
across and 3 inches deep.

Figure 32.4

d.

A Micro Cleaning Kit can be purchased at your local
hardware store as an accessory for a shop vacuum.
Figure 32.2. Assemble the crevice tool. Figure 32.3.

Advertising
This manual is related to the following products: