Quadra-Fire QF130 User Manual

Page 34

Advertising
background image

Quadra-Fire • QFI30, QFI35 • 2227-900 Rev. H • 1/11

34

Log #2 (SRV2225-703): Mate the grate tine with the slot on the bottom of Log #2. The back end of the log rests on the log

support. The side of the log will contact the left refractory as shown in Figure 7.

Figure 7. Place Log #2

Figure 8. Slot on Log #2

Figure 9. Place Log #3

Log #3 (SRV2225-702): Position the left end of the log on the fl at spot of Log #2 as shown in Figure 7 and Figure 9. The

right end of the log rests on the log support and touches the back refractory. The left end of the log should contact the left

refractory panel.

Log #4 SRV(2225-705): Mate the slot on the bottom of Log #4 with the right log pin. Refer to Figure 11 for location of log

slot. Rotate the right end of the log clockwise until the groove on the end of the log mates with the grate bar.

Figure 10. Place Log #4

LOG CONTACTS

LEFT REFRACTORY

PANEL

FLAT SPOTS

FOR LOG #6 AND LOG #3

MATE SLOT WITH

GRATE TINE

SLOT

LOG CONTACTS LEFT

REFRACTORY PANEL

POSITION LOG

ON FLAT SPOT

LOG CONTACTS

BACK REFRAC-

TORY PANEL

FLAT SPOT

FOR LOG #7

LOG RESTS ON

LOG SUPPORT

MATE LOG

PIN WITH

LOG SLOT

MATE GRATE BAR

WITH LOG GROOVE

2

3

4

Figure 5.

Log #1 (SRV2225-701): Position the groove on the log with the right grate tine as shown in Figure 6. The opposite end of

the log will rest on the log support. Rotate the opposite end of the log clockwise until it contacts the refractory panel.

Figure 6. Location of Log #1

LOG SUPPORT

ANDIRONS

OUTER TINES

LOG PINS

PILOT

BRACKET

LOG RESTS ON

LOG SUPPORT

LOG GROOVE

CONTACTS

GRATE TINE

1

Advertising