Toshiba RAV-SM1100UT-E - Manual (Page 38)

35
REQUIREMENT
Before installation of the indoor unit, be sure to
remove the cushion for transportation between the
fan and the bell mouth. Running the unit without
removing the cushion may damage the fan motor.
Installation of ceiling panel
(Sold separately)
Install the ceiling panel according to Installation
Manual attached with it after piping/wiring work has
completed.
Check that installation of indoor unit and ceiling
opening part is correct, and then install it.
REQUIREMENT
Joint the connecting sections of ceiling panel,
ceiling surface, ceiling panel and indoor unit
closely.
Any gap between them will cause air leakage and
this generate condensation or water leakage.
Installation of ceiling opening and
hanging bolt
For installation of the wired remote controller, follow
the Installation Manual attached with the remote
controller.
• Pull out the remote controller cord together with the
refrigerant pipe or drain pipe.
Be sure to pass the remote controller cord through
upper side of the refrigerant pipe and drain pipe.
Be sure to remove the cushion for transportation
between the fan and the bell mouth.
2
SELECTION OF INSTALLATION PLACE