Transition Networks SISPM1040-182D - Manual (Page 26)

Transition Networks SISPM1040-182D
Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
3.5 Wiring the Fault Alarm Contact
The fault alarm contacts are in the middle of the terminal block connector as the picture
below shows. If configured the switch will detect power failure, or port link failure
(available for managed model) and then form an open circuit. The following illustration
shows an application example for wiring the fault alarm contacts.
[NOTE] The wire gauge for the terminal block should be in the range between 12 ~ 24
AWG.
Insert the wires into the fault alarm contacts