Tascam DP-004 - Manual (Page 3)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM DP-004 3
The unit power should be off when you install and replace batteries. •
Remove the batteries if you do not plan to use the unit for a long time. •
Batteries could rupture or leak, causing fire, injury or stains around them. If
the battery fluid leaks, wipe away any fluid on the battery case before insert-
ing new batteries.
FOR U.S.A.
TO THE USER
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures.
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and receiver.
c) Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications to this equipment not expressly approved by
TEAC CORPORATION for compliance could void the user's authority to
operate this equipment.
Declaration of Conformity
Model Number : DP-004
Trade Name : TASCAM
Responsible party
: TEAC AMERICA, INC.
Address : 7733 Telegraph Road, Montebello,
California, U.S. A.
Telephone number : 1-323-726-0303
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference recieved,
including interference that may cause undesired operation.