Tascam DP-004 - Manual (Page 34)

34 TASCAM DP-004
4–Preparations
Preparing the power and SD card
Installing an SD card
An SD card is used as recording media for recording
and playback.
Cards that comply with SD and SDHC standards •
can be used.
Cards should be at least 512 MB in size.
•
A list of SD cards that have been tested with this •
unit can be found on the TASCAM web site
(www.tascam.com).
Insert the SD card into the SD card slot inside the
battery compartment on the bottom of the unit.
1 Make sure the unit power is OFF. Open the battery
compartment and remove the batteries if they are
inside.
2 Insert the SD Card into the slot as shown in the
following illustration until it clicks into place.
3 Replace the batteries if you are using them and
close the cover.
Ejecting the card
Push an inserted card in further to eject it.