TROY Group MAN-EXT2000 - Manual (Page 126)

9-2 NetBEUI Configuration
need to set the WINS primary and secondary servers using
the commands SET NETBIOS METHOD, SET NETBIOS
PRIMARY, and SET NETBIOS SECONDARY commands from
the print server console as described in Appendix A. This is
not required if you are using NetBEUI only.
Print Server Configuration
To use the print server with a Microsoft network, you must
know which domain it resides on. By default, Microsoft
networks use the domain name WORKGROUP, so if you
have not specifically configured a domain name for your
network, you may use the name WORKGROUP and skip the
remainder of this section.
If you have a different domain name, then you must
configure this name into the print server. To do this, you
may use XAdmin32, XAdmin, WebXAdmin, or the print
server console to connect to the print server (refer to Chapter
3 for information on installing and using these utilities):
• With XAdmin32, double click on the print server name
and then click on the Microsoft tab. Then enter the
desired domain name.
• With WebXAdmin, click on Configure Microsoft and
then enter the desired domain name.
• With the print server console, enter the command:
SET NETB DOMAIN domainname ,
where domainname is the desired domain name.