TROY Group MAN-EXT2000 - Manual (Page 128)

9-4 NetBEUI Configuration
5. You will be asked to enter a port name, which must
begin with "NB" (for example
NB23 ). Enter the
desired name or accept the default NB1 . Click OK.
6. Select Browse when asked for the Remote Print Server.
- Choose the desired workgroup and click Next.
- Choose the TROY XCD print server from the list of
available devices. The default name of the print
server is XCD_xxxxxx, where "xxxxxx" is the last six
digits of the Ethernet address (for example,
XCD_035893).
- Choose the desired printer (service) from the list.
The default service is BINARY_P1 for the parallel
port, BINARY_S1 for the serial port, BINARY_P2
for the XConnect 100 second parallel port, and
BINARY_S2 for the second serial port..
- Click Finish and then OK.
7. Click Finish to restart the computer.
Note: Print servers with firmware versions 3.58 and earlier
use an address of the form \\ XCD_xxxxxx_pp\pp,
where "xxxxxx" is the last six digits of the Ethernet address
and "pp" is the port name (P1 for the parallel port, S1 for the
serial pot, P2 for the second parallel port, and S2 for the
second serial port).
You must then create a local (not network) printer on your
system that uses this port. First go the Networks icon in the
Control Panel on your workstation and make sure that you
have the following enabled:
- TCP/IP or NetBEUI protocol
- Client for Microsoft Network
- Appropriate Ethernet LAN adapter card