TROY Group MAN-EXT2000 - Manual (Page 19)

Installation 2-5
Figure 2-3
Pony Print Server Plus and Pony 100 Switches and LEDs
Step 1-b XConnect 100, Pony 100, and
Pony Print Server Plus Switches
Important Note: Skip this step if you have an XConnect II
or XConnect II lite.
The XConnect 100, Pony 100, and Pony Print Server Plus
have a single pushbutton switch test switch (see figures 2-2
and 2-3). This switch does not need to be used during the
configuration process. It has the following functions:
• To print a self-test page, press the switch in for at least
one-eighth second but less than five seconds.
• To reset the unit back to factory default settings, press the
switch and hold it in for at least 5 seconds
Test LED (Top)
Test/Factory
switch
Power connector
Test/Factory
switch
Pony Print Server
Plus
Pony 100
Serial port 100baseTX/10baseT
connector
Power connector
TEST LED Link LED