TROY Group MAN-EXT2000 - Manual (Page 220)

B-4 Using Services
Note that the string numbers within the quotation marks are
expressed in hexadecimal when used with this command.
To associate a string with the service, use the following
commands:
SET SERVICE servicename BOT stringnumber
SET SERVICE servicename EOT stringnumber
where servicename is the name or number of the service and
stringnumber is the number of the string as defined above.
The first command (BOT) adds the specified string to the
beginning of the job, while the second command (EOT) adds
the specified string to the end of the job. A given service can
have both a setup and reset string associated with it.
To clear a string number, type:
CLEAR SERVER STRING stringnumber
To clear a setup or reset string, set the string number to 1
(the null string):
SET SERVICE servicename BOT 1
SET SERVICE servicename EOT 1
Enabling Protocols on a Service
You may enable or disable protocols that can access a given
service with the following commands:
SET SERVICE name LAT ENABLED
SET SERVICE name IP ENABLED
SET SERVICE name NETWARE ENABLED