Toshiba TF 610 - Manual (Page 35)

35 GB TF 610 TOSHIBA
Set resolution
In its basic setting, your fax machine uses
high resolution for transmitting or copying
your documents. You can however also
adjust the resolution to suit the particular
documents. Use the following as a rough
guide:
STD (basic setting) For hand-written
or typewritten documents
FINE For documents with small type
such as newspapers and
diagrams
SF For documents with very small
and detailed diagrams
GREY 64 grey stages for photographs
or colour documents
Higher resolution has an impact
on transmission time!
To change the resolution, press
the MODE key several times. The
LEDs above this key indicate the
set mode:
LED lit LED lit LED lit LED lit LED lit mode set mode set mode set mode set mode set
FINE fine resolution
S-FINE superfine resolution
GREY STAGE grey-stage mode
all off standard resolution
Redial
If it was not possible for your fax message
to be sent, this may be due to various
reasons (please read
page 65 ). One
reason may be that the other fax machine
is busy. In this case, it would make sense
to call your partner again at a later time.
This is done automatically by your fax; it
attempts to send the fax message again
approx. every three minutes.
The quantity of last number redial
attempts and the relevant intervals
between attempts can be set in the user
functions (
see page 52 ).
If you have established a
connection via the MONITOR
key, you can redial a number
using the REDIAL/PAUSE key.
Transmit documents
Transmit documents