Toshiba TF 610 - Manual (Page 5)

5 GB TOSHIBA TF 610
Remove transport
fittings:
Preparation
Before you start to use your fax machine,
please remove all transport fittings as
illustrated.
Insert process unit:
In order to transport or move
the machine the toner pack and
the process unit has to be
removed.
When installing the machine for the first time
and later when CHANGE PROC. UNIT is
displayed, insert the new process unit as
decribed below.
Open the control panel and housing
cover as illustrated.
1. The fixer cleaner
This is inserted when installing your machine
for the first time and each time the process
unit is replaced:
Open the control panel cover to the front. Slide
the cleaner underneath to the right, lift and
remove.
Insert the new cleaner first on the right, then
press down firmly on the left.
2. Prepare the process unit
Place a sheet of paper on an even surface and
lay the process unit on this. Remove the seal.
When holding the protective foil, be sure to
avoid contact with any toner.
The print volume achieved with the
first filling of the toner cartridge is less
than that achieved with subsequent
fillings.
Preparation
Transport fittings
Transport fittings
Transport fittings
Transport fitting