Toshiba TF 610 - Manual (Page 63)

63 GB TOSHIBA TF 610 Possible problems
Possible problems
Error codes in journal
The display message transmission error is
expained by the indicated error code.
The same code if shown also in the in the
jounal and transmission repot.
Press STOP to clear error messages.
Code Number
STOP
OK
001
002
003
005-007
008
009-011
014
020
100-103
104-106
111
112-126
141
142-157
252-355
Cause
The transmission is interrupted by the stop
button.
The document has been transmitted without
any errors.
Top cover or rear cover open
Paper jam or document too long. Is the
memory full? Ask your dealer for a memory
extension.
Recording paper jam or recording paper
cassette is empty
Line error
Line error
Line error
Printing error
Errors on the line mean that parts of the
document are difficult to read; however, the
document is transmitted completely.
Line error
Unsuccessful polling
Mailbox transmission
Line error
Line error
Line error
A remote control error occurs
How to correct
Try again
This is how it should be
Close all parts
Remove the document. See also page 67
Send the document from the document
feed
Remove jammed paper or load new
paper without switching off the machine,
see
page 67
Repeat transmission, try switching over to
4800 BPS.
No telephone line was detected.
Repeat transmission, try switching over to
4800 BPS.
Check toner, process unit and paper
transport
No special measures necessary. If this
frequently occurs with one particular fax
partner, switch over to 4800 BPS.
Repeat transmission, try switching over to
4800 BPS.
An incorrect password has been used, or
no document was loaded for polling
An attempt has been made to transmit a
document to a box or relay. Check
whether a TF 861/831/631 is installed at
the far end.
Repeat transmission, try switching over to
4800 BPS.
No telephone line was detected.
Repeat transmission, try switching over to
4800 BPS.
Consult your dealer