Univex PowerLite 700 - Manual (Page 78)

78 Maintaining the Projector
Replacing the Remote Control Batteries
Replace the batteries in the remote control as described below:
1. Turn the remote control over.
2. Press in on the catch on the battery cover as you lift the cover off.
3. Install two AA alkaline batteries, inserting the + and – ends as
shown.
4. Replace the battery cover and press it down until it clicks into
place.
caution
When replacing batteries,
take the following
precautions:
■ Replace the batteries as
soon as they run out. If the
batteries leak, wipe away
battery fluid with a soft
cloth. If fluid gets on your
hands, wash immediately.
■ Do not expose batteries to
heat or flame.
■ Dispose of used batteries
according to local
regulations.
■ Do not use batteries other
than those specified in this
User’s Guide and do not
use batteries of different
types or mix old and new
batteries.
■ Keep these batteries out of
the reach of children.
Batteries are choking
hazards and are very
dangerous if swallowed.