Universal Laser Systems CLP-100NI-NPRT - Manual (Page 13)

13
QUICK START
13 - Replace the Knurled Cover Retaining Knob “K” and
lightly tighten. Do not over tighten this knob or you may
bend the top of the Knurled Drive Wheel Cover “J” and
cause it to bind against the Knurled Drive Wheel. Now
retighten the Pivot Arm Knurled Knob.
11 -Replace the Knurled Drive Wheel “G” by aligning the 3
small holes with the 3 stainless drive pins on the top of the
Transfer Roll “N” and pressing the Drive Wheel onto the
Transfer Roll.
12 -Replace the Knurled Drive Wheel Cover “J” and rotate it into
position with the flat edge directly facing the Print Drum.
The tops of the stainless pins will be flush with the top of the
Drive Wheel when seated properly.
Hold the Drive Wheel Cover and Inking System Cover in
place.
The Cover Retaining Knob should be just tight enough to keep
the Inking System Assembly together and prevent the Drive
Wheel Cover from rotating out of position.
FIGURE 23
FIGURE 24
FIGURE 25