Universal Laser Systems CLP-100NI-NPRT - Manual (Page 34)

34
MAINTENANCE
8- Reinstall the Index Ramp in the proper orientation for your mounting configuration as shown in
Figures 64 & 65.
1- To replace Print Drum Index Springs, rotate the Print Drum approximately 3/4 turn to relieve spring
tension as shown in Figure 59, Page 32.
REPLACING PRINT DRUM INDEX SPRINGS
2- Using a small screwdriver, remove the two Snap Rings on
the Index Spring Assembly.
3- Remove the Index Spring Assembly by lifting it straight up off
the pivot pins.
RIGHT HAND CONFIGURATION
LEFT HAND CONFIGURATION
FIGURE 66
FIGURE 67
FIGURE 64 FIGURE 65