Universal Laser Systems CLP-100NI-NPRT - Manual (Page 29)

29
MAINTENANCE
3 - Blot the surface of the die with a clean paper towel to dry
as shown in and reinstall the clean dies on the coder.
CLEANING THE PRINTING DIES
1 - Place the contaminated Printing Die on top of several lay-
ers of paper towels to absorb the excess solvent. Pour
just enough solvent on the face of the die to cover the die
face.
2 - Using the toothbrush, carefully scrub the face of the die to
remove the contamination and old ink as shown in. Add more
solvent as necessary and repeat the process until the die is
clean.
Do not submerge or soak the dies in solvent as this may cause
swelling of the rubber compound.
All inks which are formulated for printing on non-porous surfaces contain a resin binder which bonds the dye or
pigment in the ink to the surface of the material being printed. As the ink begins to dry, this binder becomes
“tacky” or “sticky”. While in this stage of the drying process, the tack on the dies will tend to pick up both airborne
dust and any dust or dirt on the surface of the material being printed. When this happens, the dies should be
cleaned or replaced. The easiest method of cleaning the dies requires the appropriate solvent for the ink being
used, a pair of rubber gloves, safety glasses, an apron to protect your clothing is recommended, a toothbrush,
some clean paper towels and a plastic bag to protect your workbench from staining. (Naturally, the toothbrush
will never be suitable for oral hygiene use after this process.)
After some period of use, the accumulation of contaminates on the dies will cause degradation of the print quality;
cleaning the printing dies, excluding excessive wear to the die face, will restore the print quality of the coder.
FIGURE 51
FIGURE 52
FIGURE 53