Carton printing – Universal Laser Systems CLP-100NI-NPRT User Manual

Page 24

Advertising
background image

24

CARTON PRINTING

Before tightening the mounting bolts, check alignment of the print drum. It is very important for proper tracking
that the top of the print drum is parallel to the top of the conveyor (Figure 41) and the side of the print drum is
parallel to the side of the carton (Figure 42). Once this alignment has been achieved, tighten the mounting bolts.

Universal Non-Porous Conveyor Line Printers are designed so the frame of the machine will pivot on the mount-
ing column. This allows the print drum to deflect, or swing, on contact with the leading edge of the carton a
maximum of 2". It is recommended that cartons be aligned between guide rails with no more than 1/4" clearance
on each side as shown in Figure 40. This should allow ample clearance for cartons and protect your printer from
damage.

In most applications, installation of the printer can be accomplished by attaching the mounting bracket to the side
rails of the powered conveyor using two 3/8" machine bolts. The printers should be mounted as close as
possible to the end of the guide rails to ensure that proper carton alignment is maintained at the printing station.

IMPROPER

TOP ALIGNMENT

PROPER

TOP ALIGNMENT

IMPROPER

SIDE ALIGNMENT

PROPER

SIDE ALIGNMENT

FIGURE 40

FIGURE 41

FIGURE 42

CLEARANCE 1/4”

CLEARANCE 1/4”

PRINTERS MOUNTED IN

CLOSE PROXIMITY TO

END OF GUIDE RAILS

GUIDE RAILS

Advertising