Universal Laser Systems CLP-100NI-NPRT - Manual (Page 38)

38
When adequate pressure is applied to the Eccentric Knob dur-
ing assembly, the knob should have a moderate resistance to
turning. When assembled properly, the ink roller axle should be
feel rigid.
MAINTENANCE
5 - Install the Eccentric Knurled Knob and align the engraved
line on the knob with the “MAX” line on the Inking System
Cover. Set the ink roller axle on a small block of wood or
metal . The block used should be tall enough so the entire
assembly is supported by the ink roller axle (the Inking Sys-
tem Cover should not touch the table top).
FIGURE 78
FIGURE 79
6 - Press down firmly on the Eccentric Knurled Knob. While
holding pressure on the knob, tighten the two set screws.