Maintenance, Tension arm assembly conversion – Universal Laser Systems CLP-100NI-NPRT User Manual

Page 31

Advertising
background image

31

1- Loosen the Lock Nut and screw the Adjusting Bolt in to relieve the spring pressure (Figure 56).
2- Remove the spring by lifting the end off the Locating Button.
3- Remove the Adjusting Bolt and replace it on the opposite side of the Tension Arm.
4- Remove the Spring Cup and replace it on the opposite side of the Tension Arm.
5- Replace the Spring by inserting one end into the Spring Cup and lifting the other end over the

Locating Button.

6- Readjust the position of the Adjusting Bolt to center the Tension Arm between the sides of the

coder base plate. Snug the Lock Nut against the Tension Arm to prevent movement from conveyor
vibration.

TENSION ARM ASSEMBLY CONVERSION

FIGURE 56

10 -Reinstall the Inking System Assembly and adjust as explained on Page 9 - Installing the Inking

System Assembly.

SPRING CUP

LOCATING

BUTTON

SPRING

LOCATING

BUTTON

ADJUSTING BOLT

LOCK NUT

TENSION ARM

MAINTENANCE

SET SCREW POSITION

FOR RIGHT HAND MOUNT

SET SCREW POSITION

FOR LEFT HAND MOUNT

BOTTOM VIEW OF

INKING SYSTEM BASEPLATE

FIGURE 55

Advertising