Maintenance, Inking system assembly – Universal Laser Systems CLP-100NI-NPRT User Manual

Page 37

Advertising
background image

37

MAINTENANCE

INKING SYSTEM ASSEMBLY

The following steps will guide you through the Ink Roll Eccentric Assembly.

1 - Install the O-Ring in the groove of the Eccentric flange,

then install one of the white delrin washers on the Eccen-
tric.

FIGURE 74

FIGURE 75

FIGURE 76

FIGURE 77

2 - Apply a thin coating of grease to the O-Ring and the Ec-

centric to approximately 1/2” from the flange.

ALIGN DIMPLES

3 - Insert the Eccentric into the Inking System Cover. Rotate

and pull the Eccentric from the opposite side until the o-
ring slips into the bore. When fully seated, the flange of
the eccentric will be approximately 0.010” above the sur-
face of the cover. Rotate the Eccentric and align the dimple
on the Eccentric flange with the dimple in the cover.

4 - Install the second white delrin washer over the Eccentric.

Automotive wheel bearing grease is recommended.

ECCENTRIC O-RING

ECCENTRIC O-RING

ALIGN DIMPLES

Advertising