Choosing a site – Vanguard Managed Solutions 650 User Manual
Page 33
Installing 650 Series Hardware
2-3
Choosing a Site
Choosing a Site
Introduction
This section describes how to choose an appropriate site for your Vanguard 650
Series hardware.
How to Choose a
Site for the
Vanguard 65x
Choose a site that is within an appropriate distance of a power source. Depending on
your application, and the country in which the Vanguard 650 Series will operate, the
power source must be a grounded 100 to 240 VAC outlet.
To avoid overheating the circuitry, never place anything on top of the unit. Also,
leave at least 2 inches (5 cm) of clearance in front of the front panel, to allow you to
see the unit’s LEDs, and behind the unit for interfacing cable clearance, as shown in
Figure 2-2.
The selected site should be free of accumulated dust and environmental extremes.
Figure 2-2. Proper Cable and Air Clearance
Minimum 2 inches (5cm)
Front and Rear
Do Not Place
Anything on Top
of Unit