Vanguard Managed Solutions 650 - Manual (Page 60)

3-22 Installing and Coldloading 650 Series Software
Selecting a Predesigned Configuration
Restoring
Configurations
Using Kermit This table describes how to restore a configuration using Kermit.
Step Action Result
1 Access the control port, and from
the Main menu, select
Configuration Save/Restore. The Configuration Save/Restore
menu appears.
2 From the Configuration Save/
Restore menu, select KERMIT
Restore Configuration. Characters such as # N3 appear at
the prompt.
3 Select the name of the CMEM from
the PC’s disk that you wish to
restore.
4 Depending on the communications
program installed, the steps for
using Kermit may vary. Follow the
directions to receive a file using
Kermit. After approximately 20 to 30
seconds, you will receive the
following message:
Receive complete: File stored
successfully.
If... Then...
The transfer failed because too
much time elapsed. Try again.
The transfer failed due to
communications program
problems. Refer to the communications
program documentation for
additional information.
5 Warm boot the node to implement
the configuration that was
transferred.