Vanguard Managed Solutions 650 - Manual (Page 37)

Installing 650 Series Hardware 2-7
Powering Up the Vanguard 650 Series
Powering Up the Vanguard 650 Series
Introduction This section describes the sequence of events when you power up a Vanguard 650
Series device.
Powering Up The Vanguard 650 Series does not have a power switch on the unit. Therefore,
follow these steps to power on the Vanguard 650 Series:
Diagnosing Start-
up Failures The front LEDs on the 650 Series (Figure 1-3) will help you to follow the progress of
the unit’s power up. The following identifies the types of failures you may encounter.
Step Action
1 Plug the small round DIN type connector of the power supply into the
power socket on the Vanguard 650 Series back panel.
2 Connect the power cord into the power supply outlet.
Failure Description Action
Hardware
Failure If the TEST light turns on and
remains on, one or more of the
diagnostic tests have failed,
indicating a hardware problem. Contact Customer Support for
possible repairs to your Vanguard
650 Series products.
Powerup
Failure If the STATUS light blinks
continuously, at a constant rate,
the software bundle in Flash
memory is corrupted. Perform a coldload of the
software option bundle.