Vista Ademco N7227V5 - Manual (Page 42)

VISTA-10SE Installation and Setup Guide
12-2
If a different Installer code is subsequently programmed, use it instead of 4111 to gain
access to the Programming mode.
When you enter the Program mode, data field ✱ 20 is displayed (this is the first data field in
the system). The system now accepts entries for field ✱ 20.
Programming a Data Field
1. Press [ ✱ ]+ Field No. (for example, ✱ 21), then make the desired entry.
2. When you have completely programmed a data field, the keypad beeps three times and
then automatically displays the next data field in sequence. To go to a different field,
press [
✱ ] plus the desired field number.
3. If the number of digits that you need to enter in a data field is less than the maximum
digits available (for example, the phone number field), enter the desired data, then press
[
✱ ] and the next data field number to be programmed.
4. If you try to enter a nonexistent field, the keypad will display NOT USED EE (Entry
Error). Simply re-enter [ ✱ ] plus a valid field number.
Reviewing a Data Field/Erasing an Entry
Press [#] + Field No. Data is displayed for that field number. No changes are accepted in
this mode.
To delete an entry in a field, press [ ✱ ] + Field No. + [ ✱ ] (applies only to fields ✱ 40- ✱ 43, and
✱ 94).
Interactive Mode Programming ( ✱ 56, ✱ 58, ✱ 80, ✱ 81, and ✱ 82)
Typical prompt displayed
during Interactive mode
programming:
Enter Zn Num.
(00 = Quit) 01
Zone Number Ç
Press [ ✱ ] + Interactive Mode No. (for example, ✱ 56). The
alpha keypad displays the first of a series of prompts requesting
entries.
A detailed procedure (with displays of prompts) is provided in
later sections of this manual.
Interactive Mode Used to Program
✱56 Zone Programming Zone characteristics, report codes, alpha
descriptors, and serial numbers
✱58 Expert Mode
Programming
Zone characteristics, report codes, and
serial numbers.
✱80 Output Relay
Programming
4204 Relay module
✱81 Zone List
Programming
Zone lists for relay control
✱82 Alpha Programming Zone alpha descriptors
Loading Factory Defaults
To load the factory defaults, enter the Programming mode, press ✱ 97, then exit the
Programming mode.
Do not press ✱ 97 to load defaults if any programming has been done previously. If you do, data
already programmed into the system will be changed!
✱ 96 resets all the subscriber account numbers and CSID in preparation for an initial
download.
Exiting the Programming Mode
✱ 99 allows re-entry into the Program mode using Installer Code + 8 0.
✱ 98 prevents re-entry into the Programming mode using the Installer code.