Vista Ademco N7227V5 - Manual (Page 76)

VISTA-10SE Installation and Setup Guide
18-2
P r o g r a m A l p h a ?
0 = N o , 1 = Y e s 0
2. Enter ✱ 82. The “Program Alpha ?” prompt appears.
If you press 0 (No), proceed to step 4.
C u s t o m W o r d s ?
0 = N o , 1 = Y e s 0
3. By pressing 1 (Yes) in step 2 above:
The “Custom Words ?” prompt appears. Proceed to the six
steps for Adding Custom Words later in this section.
4. By pressing 0 (No) in step 2: The system then
automatically displays the default descriptor for zone 01.
Default Descriptor
↓
✱ Z N 0 1 Z O N E 0 1
If a descriptor was not entered previously for zone 01, the
default descriptor for zone 01 will be displayed.
Note that no entries can be made. Entries can be made only
when the display contains a flashing cursor, which signifies
the “entry mode.”
Flashing Cursor (system is
ready for entry of word).
↓
✱ Z N 0 1 A
5. To delete or change the default descriptor for zone 1,
press [
✱] plus the same zone number (01). This will
clear that descriptor and gain access to the entry mode
with flashing cursor, allowing changes to be made.
NOTE: If you do not wish to change the existing descriptor
for zone 01, enter [
✱] plus the next zone number for which
you wish to enter (or check) a descriptor. A summary
display for that zone will appear. You must then press [
✱]
plus the same zone number again to gain access to the
entry mode (flashing cursor) for that zone.
Flashing Cursor ↓
✱ Z N 0 1 B A C K
✱ Z N 0 1 B A C K
↑
Flashing Cursor if [6] is
pressed (system is
ready for next word).
6. Press [#] plus a 3-digit number for the first word from
the ALPHA VOCABULARY LIST on a following page.
Example: The descriptor that we wish to enter for zone 01
is BACK DOOR. From the LIST, BACK = 013.
Therefore, we enter # 0 1 3.
NOTE: If you accidentally enter the wrong word, simply
press [#] plus the correct 3-digit number for the word you
want.
7. Press [6] to accept the selected word and continue.
NOTE: If this is the only word you are using for the
descriptor, press [8] instead of [6] to save that word in
memory, and then go to step 11.
✱ Z N 0 1 B A C K
D O O R
↑
Flashing Cursor
8. Enter the 3-digit number for the next word. In our
example, the word is DOOR, whose number is “057.”
Enter # 0 5 7. This display will appear: