Vista Ademco N7227V5 - Manual (Page 87)

Section 21 – System Operation
21-3
Arming INSTANT .............. Enter code + INSTANT [7].
Arming MAXIMUM............ Enter code + MAXIMUM [4].
Quick Arming ..................... Simply press [#] key in place of code, then press
(if enabled) AWAY, STAY, INSTANT, or MAXIMUM to arm system as
desired. Note that the [#] key cannot be used in place of code
when disarming the system.
Disarming............................ Enter code + OFF [1].
Bypassing Zones ................ Enter code + BYPASS [6] + zone number(s).
Forced (Quick) Bypass ..... To automatically bypass all faulted zones, use
(if enabled) the "Quick Bypass" method:
Enter code + BYPASS, then wait for all open zones to be
displayed. Arm when display indicates “Bypass” and “Ready to
Arm”.
Chime Mode ........................ Enter code + CHIME [9].
To turn chime off, enter code + CHIME again.
SUMMARY OF ARMING MODES
Features for Each Arming Mode
Arming
Mode
Exit
Delay
Entry
Delay Perimeter
Armed
Interior
Armed
AWAY Yes Yes Yes Yes
STAY Yes Yes Yes No
INSTANT Yes No Yes No
MAXIMUM Yes No Yes Yes
Panic Keys
There are three individual panic keys or, on some keypads, panic key pairs. If programmed,
they can be used to manually initiate alarms and send a report to the central station.
Each key (or key pair) can be individually programmed for 24-hour Silent, Audible, Personal,
or Fire Emergency responses. The panic function is activated when both keys of the
appropriate key pair are pressed at the same time, or the appropriate lettered key is pressed
for at least 2 seconds.
OFF AWAY STAY
INSTANT CODE CHIME
MAX TEST BYPASS
READY
PANIC
1 2 3
6 5 4
8 9 7
0 * #
ARMED READY
A
B
C
D
Shown above is a typical alpha keypad with
individual Panic keys (shown lettered).
The panic functions are identified by
the
system as follows:
Keys Displayed as Zone
[A], or [1] & [✱] 95
[B], or [ ✱ ] & [#] 7
[C], or [3] & [#] 96
Notes:
• Keys [A], [B], [C] are not on all
keypads.
• Key [D], if present, is not active here.
Important: For the Silent Panic functions to be of practical value, the system must be
connected to a central station.