Xantrex Technology GT3.0 - Manual (Page 52)

Installation
2–24 975-0131-01-01
To attach the fan assembly to the inverter:
1. Using a Phillips screwdriver, remove the four panhead screws and washers
from the front panel of the inverter (two screws on each side), immediately
below the heat sink (see Figure 2-12).
2. Place the fan bracket with screw holes overlapping the screw holes on the
inverter. The fans should be facing up, on the upper side of the fan bracket.
3. Replace the four panhead screws and washers removed in step 1.
Figure 2-12 Attaching the fan assembly