Xantrex Technology GT3.0 User Manual
Page 53
Installing Accessories
975-0131-01-01
2–25
To connect the fan wires:
1.
Remove the wiring box cover by removing the two screws on the underside of
the wiring box. Removing the wiring box cover will expose the screws that
secure the front panel cover.
2.
Remove the front panel cover by removing the two screws on the underside of
the front panel.
3.
Plug the wire leads from the fan assembly into the pin connectors on the DC
circuit board. The pins are located to the left of the LCD below the ground
fault protection fuse.
4.
Replace the front panel cover using the screws removed in step 2, with the
wire leads passing through the notch at the top of the cover, ensuring that the
wires are not pinched.
5.
Replace the wiring box cover using the screws removed in step 1.
Figure 2-13 Location of Fan Connector
Fan connectors