Xantrex Technology GT3.0 - Manual (Page 75)

Replacing the Wiring Box Cover
975-0131-01-01 4–3
Replacing the Wiring Box Cover
After performing the voltage checks, replace all covers that were removed during
installation and startup.
If the front panel cover was removed from the GT Inverter, then it must be
replaced before the wiring box cover is replaced.
To replace the front panel cover:
1. Place the cover in position on the front panel, being careful not to pinch any
wires. The fan wires should pass through the notch in the upper edge of the
front panel cover.
2. Ensure that the two screw holes in the bottom of the front panel cover are
aligned with the corresponding holes in the bottom of the inverter (not the
wiring box).
3. Replace the two screws removed when the cover was removed (see
“Installing the Fan Assembly” on page 2–23), and tighten securely.
To replace the wiring box cover:
1. Place the cover in position on the wiring box, being careful not to pinch any
wires in the wiring box.
2. Ensure that the two screw holes in the bottom of the wiring box cover are
aligned with the corresponding holes in the bottom of the wiring box.
3. Replace the two screws removed when the cover was removed (see
“Accessing the Wiring Terminals” on page 3–2), and tighten securely.
WARNING: Shock hazard
Before reattaching covers, turn OFF the breaker switches in the main utility service panel
and the AC/DC Disconnect switch on the GT Inverter.